-40%

24 Volt 10 Amp Digital Programmable Charge Controller & Relay Driver Module

$ 20.3

Availability: 96 in stock
  • Type: Charge Controller
  • Non-Domestic Product: No
  • All returns accepted: Returns Accepted
  • Model: EZDIGMC_24V_10A
  • Refund will be given as: Money Back
  • Modified Item: No
  • Custom Bundle: Yes
  • Restocking Fee: No
  • Voltage: 24 V
  • Brand: Missouri
  • Condition: New
  • MPN: EZDIGMC_24V_10A
  • Amps: 10A
  • Bundle Description: This Charge Controller also includes long 5 foot battery sense leads with ring terminals. Also includes wires for connections to the relay.
  • Return shipping will be paid by: Buyer
  • Item must be returned within: 30 Days

    Description

    Free shipping to the US lower 48 states only
    excluding Alaska, Hawaii, PR
    24 Volt Digital Programmable Charge Controller & Relay Driver Module
    (Controller Only)
    Built in digital display and intelligent dual processor controller
    The charge controller has an internal relay capable of switching up to 10 amps of wind or solar.  If you will be switching more than 10 amps of power please install up to 3 external
    mechanical relays
    or up to 100
    solid state relays
    .
    Dual (2) Microprocessor controlled -- Very stable and very accurate
    Multiple user changeable settings, and trip points for many various system requirements and applications- You can change the dump point voltage level, end of dump voltage level, length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)  The controller will also monitor the diversion/disconnect activity and increase it's duration several times when your batteries are full. This feature is also adjustable.
    Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board.
    Battery Status LED - Lets you know your battery's actual voltage!
    Green LED on board lets you know it's in dump mode
    Plug & Play - Long leads for easy termination to your 24 volt battery or battery bank.
    Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
    You can connect both wind and solar at the same time
    Reverse polarity protection
    Ultra low power consumption even with the volt meter on (almost negligible). You can even set the volt meter to turn off after in-activity.
    Be aware of cheap, less capable knock-offs of our model controller that are too basic to properly charge a battery. They will attempt to only turn ON and OFF for the SAME length of time, every time, when your battery is full. This will constantly boil your battery when it's full or not properly fill it or both.
    An improperly charged battery will have a short life and cannot be brought back. One to two years instead of 10 years or more life! You don't benefit from returning a product after it ruins your system.
    A charge controller must operate a relay whether mechanical or solid state(SSRs). The relay turns the charging from your solar, wind, hydro ON or OFF to your batteries. You will need a relay with this controller brain.
    If you have 100 amps of solar charging being turned ON and OFF to your batteries, you NEED to vary the time between the ON/OFF cycles. Our controller has custom programming that cannot be duplicated by the Dime Store sellers and is, of course, user changeable.
    Ours will more slowly top-off your battery! It will do this by adjusting itself every time your battery is full by increasing the duration of the next OFF cycle by up to 4 increased OFF times.
    For example:
    5 seconds to 10, then 10 to 20, then 20 to 40 and will maintain a 40 second OFF time.
    You can adjust the starting 5 seconds down to 1 or up to 999. We even went a step further and programmed in a "sweep time" which is a secondary sensing timer that starts directly following an ON cycle. This tells the controller that it has or has not been too long before battery charging is needed again. The user adjustable sweep time allows the user and controller to have a wide range of charging times on any size battery bank.
    We also pre-wire and pre-program ours for you to be able to get up and going without becoming an expert. You're taking a risk with your system if accepting a too-good-to-be-true price or product description. If you're not convinced this is the controller for you, please check our other charge controllers or ask us which one is right for you.
    Product Documents:
    Wiring Diagram
    Charge Controller Manual
    CLICK HERE TO SEE OUR FULL LINE OF WIND AND SOLAR PRODUCTS!
    We do not mark items as gifts or under report values for customs. For International buyers,
    it is strongly recommended to check your own country's tax practices as we do not
    pay your taxes, duty or customs fees.
    Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
    We do not over charge for shipping; it is simply what the shipping calculator comes up with.
    UPS orders shipped signature required at our discretion!! Contact us right away if you need to make other arrangements!
    Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.